Fujitsu Airstage J-II Series Design & Technical Manual page 791

2-22-1. SETTING METHOD
„ WIRED R.C.(Touch panel)
„
z Step1: RB unit function setting (Case of VR-II series)
„
Set SET2 of DIP switch to "Priority given to administrative indoor unit" with function setting of
RB unit. (SET2-1: OFF, SET2-2:ON)
→Refer to 2-9. RB UNIT.
z Step1: Outdoor unit function setting (Case of V-II series)
„
Set to "Priority given to administrative indoor unit" with function setting of outdoor unit.
→Refer to 2-1. OUTDOOR UNIT.
z Step2: Wired remote controller setting
„
1) Touch the [Master Indoor Unit Setting] on the
"Initial Setting" screen.
Initial Setting
Master Indoor
R.C. Sensor
Unit Setting
Setting
Password Setting
Previous
Back
Page
3) When the [Yes] is touched, after the data
is transmitted to the indoor unit, the display
returns to the "Master Indoor Unit Setting"
screen.
Master Indoor Unit Setting
The connected indoor unit will be
set as the master indoor unit. OK?
No
NOTE:
● When changing the Master Indoor Unit, first cancel the setting of the indoor unit currently set as the Master Indoor
Unit. Otherwise, a different indoor unit cannot be registered as the Master Indoor Unit.
Page 2/ 3
Display Item
Setting
Next
Page
Yes
2) "Master Indoor Unit Setting" screen is displayed.
When the [Set] is touched, a verification screen is
displayed.
Master Indoor Unit Setting
Master Indoor Unit Setting
Not Master Indoor Unit
Back
4) When the [Back] on the "Master Indoor Unit
Setting" screen is touched, the display returns to
the "Initial Setting" screen.
Master Indoor Unit Setting Master Indoor Unit Setting
Master Indoor Unit Setting Master Indoor Unit Setting
Master Indoor Unit Master Indoor Unit
Back Back Reset Reset
*1: To clear a master indoor unit, touch [Reset]. ("Reset" cannot
be performed while the indoor unit is operating.)
- (07 - 144) -
Set
*1