Fujitsu Airstage J-II Series Design & Technical Manual page 756

„ SWITCHING SELECTION OF FUNCTION SETTING MODE
„
3) To activate the function setting mode, hold down the three buttons of SET TEMP. q , SET
TEMP. p and FAN at the same time for 5 seconds or longer.
„ BUTTON NAME AND FUNCTION
„
● During function setting mode, indoor unit reject the any operation command from remote controller.
Function number
Refer to FUNCTION DETAILS
Remote controller address
Remote controller address
setting number 00-15
FAN button
Each time this button is
pressed, the fan setting
changes among "Remote
controller address," "Function
number" and "Setting number."
Function number
Refer to FUNCTION DETAILS
Remote controller address
Remote controller address
setting number 00-15
FAN button
Each time this button is
pressed, the fan setting
changes among "Remote
controller address," "Function
number" and "Setting number."
Function setting mode initial display
UTY-RSKU (With operation mode)
UTY-RHKU (Without operation mode)
- (07 - 109) -
Setting number
Refer to FUNCTION DETAILS
START/STOP button
Transmits function setting
SET TEMP. " " and "q" button
p
Switches the various numbers.
Setting number
Refer to FUNCTION DETAILS
START/STOP button
Transmits function setting
SET TEMP. " " and "q" button
p
Switches the various numbers.