Fujitsu Airstage J-II Series Design & Technical Manual page 746

„ COMPLETION OF FUNCTION SETTING MODE
„
11) When the [Back] on the "Function Setting" screen is touched, the display returns to the
"Maintenance" screen.
Function Setting
Address
Function No.
Setting No.
Back
„ SETTING UP EACH INDOOR UNIT
„
Indoor unit
01
Wired remote
controller
(Touch panel)
Repeat the procedures in steps 1) through 11), and set up the indoor units
requiring address setting.
„ RESET THE POWER AFTER SETTING UP ADDRESS OF ALL
„
INDOOR UNITS
Important
¾ If power is not reset, address will not read correctly.
„
¾ After all the addresses have been set, the circuit breaker needs to be switched off
„
for at least 2 minutes.
After the 2 minutes has passed, power can be restored.
¾ The set address is stored in the PCB and will remain in memory even when the
„
power is turned off.
Address setting will only be effective after power has been reset.
Record the address set in the indoor unit on a label, etc., and affix the label to the
unit so it can be used for after-sales service operations.
[002–01]
[30]
[01]
Setting
Indoor unit Indoor unit
00 01 01 01 02
0 0 0
- (07 - 99) -
Indoor unit Indoor unit
01 13 01
0
Wired remote
Wired remote
controller
controller
(Touch panel)
(Touch panel)
Indoor unit
14 01 15
0 0