Replacing A Water Sensor (Rope Type) - Huawei FusionModule 1000B Maintenance Manual

FusionModule1000B Air-Cooled IT Solution
Maintenance Guide
Figure 6-15 Removing a point-type water sensor
Step 3 Install a new water sensor and tighten the screws.
Step 4 Connect cables to the water sensor.
Step 5 Check that the new water sensor is working properly.
----End
Follow-up Procedure
Dispose of the removed water sensor that is confirmed faulty.

6.3.3 Replacing a Water Sensor (Rope Type)

Prerequisites


Impact on the System
None
Preparations
Tools: Phillips screwdriver, protective gloves
Materials: spare water temperature sensor
Documents: monitoring device layout, management system initial configuration table
Skill requirement: weak-current engineer
Issue 02 (2017-01-10)
Drip a small amount of water onto the water sensor. If the monitoring software terminal generates an
alarm, the water sensor is working properly.
A water sensor needs to be replaced.
Spare water sensors of the same model are available and functional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Parts Replacement
98