Toshiba e-STUDIO2010AC Imaging Manual page 102

2.Copier-specific Adjustments
(3) Select [05 ADJUSTMENT MODE]. Change the values for codes [7056] to [7058], [7061], [7062],
[7249] and [7794] to [7806] to adjust the default value for the sharpness intensity.
• Increasing the sharpness intensity will enhance the edges of the image.
Color mode Original mode
Text/Photo
Printed Image
Full color
User Custom
Red Seal Color
Text/Photo
Mono color
Printed Image
Text/Photo
Twin color
Printed Image
Text/Photo
Black
User Custom
Image Smoothing
Drop Out Color
• The smaller the setting value is, the weaker the sharpness intensity becomes. The larger the
setting value is, the stronger the sharpness intensity becomes.
Changing the values for these codes will change the sharpness intensity, when the [Sharpness]
indicator in the [Image] tab on the copy mode is set to the center. Remember that 1 step of the
indicator will increase or decrease the sharpness intensity by 25. If the sharpness intensity of the
center value is changed, each step of the indicator will be changed accordingly. (For instance, if
the center value is increased by "25" (sharper), the value of each step of the indicator will also be
increased by "25" (sharper).)
However, the range of adjustment values that is valid for sharpness level change is from -100 to
+100 of the total of the setting value of the [05] code and that of the indicator. For instance, if the
setting value of the [05] code is "153" ("+25" from the default value), the limit of the steps in the
sharp side of the indicator is "+3". If the step is set at "+4", the image quality will not be changed.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
[05] code Recommended value
05-7796
Text 05-7797
05-7798
Photo 05-7799
Map 05-7800
05-7795
05-7794
05-7801
Text 05-7802
05-7803
05-7804
Text 05-7805
05-7806
05-7056
Text 05-7057
Photo 05-7058
05-7249
05-7061
05-7062
2-48
Acceptable
value range
Set a value larger than
128.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Default
0 to 255 128