Toshiba e-STUDIO2010AC Imaging Manual page 71

(3) Perform color balance adjustment or RGB adjustment to adjust the tint of colors in general.
Use steps (a) through (d) to perform the adjustment.
(a) Press [Image] on Copy mode.
(b) Press [Color Balance] to adjust the color balance by changing the amount of toner (C, M, Y and
K) or [RGB Adjustment] to adjust the color balance by changing the intensity of R, G and B.
(c) Press [+] to enhance the tint of the color or [-] to decrease it.
• After selecting the color balance by changing the amount of toner (C, M, Y and K), press
[Detail]. The tint of the color can be adjusted according to density area (low, middle or high
density area).
(d) Press [OK].
After adjusting the tint of the colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(4) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7665] to [7671] to adjust
the hue.
Original mode
Text/Photo
Text
Printed Image
Photo
Map
User Custom
Red Seal Color
• Set the value in increments of approx. 15 steps while checking the copy image until the optimum
value is obtained.
• Each setting value for the Text/Photo, Text and Photo (developing paper) original mode is
reflected to the quality of the image in the Full color and Auto Color modes.
• The subcode varies according to the area where the hue is adjusted. Set the subcode for the area
to be adjusted by referring to the following below.
Target area of hue
Subcode
For adjusting the tint of
0
For adjusting the tint of
1
For adjusting the tint of
2
© 2018 TOSHIBA TEC CORPORATION All rights reserved
[05]code Subcode
05-7665
05-7666
05-7667
05-7668 0/1/2/3/4/5
05-7669
05-7670
05-7671
adjustment
Setting a larger value: The tint of Red becomes closer to
that of Y (Yellow).
Red Setting a smaller value: The tint of Red becomes closer
to that of M (Magenta).
Setting a larger value: The tint of Yellow becomes closer
to that of G (Green).
Setting a smaller value: The tint of Yellow becomes
Yellow
closer to that of R (Red).
Setting a larger value: The tint of Green becomes closer
to that of C (Cyan).
Green Setting a smaller value: The tint of Green becomes
closer to that of Y (Yellow).
2-17
2.Copier-specific Adjustments
Recommended value
0 to 255
Recommended value
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Default
128