Toshiba e-STUDIO2010AC Imaging Manual page 35

(2) Use the [Thick 1] paper mode when you print on plain paper.
• If the [Thick 1] paper mode is used, printing decelerates but image quality becomes more stable
because differences in color or temperatures during continuous printing will be reduced.
• Set the thick paper mode following steps (a) to (h) below.
(a) Press [User Functions -User-] on [Home] screen to enter the "User Functions" menu.
(b) Press [Drawer].
(c) Select a drawer that you want to set for [Thick1] paper mode.
(d) Press [Paper Type].
(e) Press [Thick 1].
(f) Select [05 ADJUSTMENT MODE]. Then select the subcode 1 for the code [2934] and
change the setting value to "3".
• Change the level of transfer roller bias offset in the color mode, the front side of paper.
Check how the copy image changes carefully. The setting value may be changed to "4" or "2"
if required.
(g) Place paper to be used on the drawer that you selected in step (d) above.
(h) Perform automatic calibration.
Refer to step (1) in "1.1 To Obtain a Darker Image".
After setting the value, print and check the image quality.
If further image quality adjustment is necessary, go to the next step.
(3) Check the life of the consumables (particularly the drum and transfer belt unit) and replace them, if
necessary.
• When replacing any consumable, use steps (a) to (b).
(a) Enter the PM support mode. Reset the counter corresponding to the replaced consumable to "0".
For further information regarding the PM support mode, refer to the Service Manual.
(b) Perform automatic calibration.
For further information regarding the procedures, refer to procedure (1) in "1.1 To Obtain a
Darker Image".
• After replacing any consumable, remember to reset the counter corresponding to it to "0".
Otherwise, it may cause a loss in MFP performance, including degradation in the image quality
and a reduction in the life of the consumables.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-23