Toshiba e-STUDIO2010AC Imaging Manual page 43

e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC
[05] Code Function
05-4001 Print
Perform adjustments according to the following procedure while checking the chart output by [05
ADJUSTMENT MODE].
<Notes>
• Since the reproduction ratio may vary due to expansion and contraction of paper immediately
after the image is printed out, it is recommended to measure its dimension after at least 3 minutes
have passed.
• Use the second drawer, A3/LD.
• Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
<Procedure>
(1)Select [05 ADJUSTMENT MODE].
(2)Key in a code and press the [START] button.
(3)Key in the adjustment value. (To correct a value, press [CLEAR].)
(4)Press [OK] to store the value. → The equipment goes back to the ready state.
(5)Check the chart.
If the image is not in the desired reproduction ratio, repeat steps (2) to (5).
(3) (b) Image distortion adjustment
Adjustment of tilted images on the trailing edge
In this procedure, it is recommended to use the print sample (05-316, 04-141, 04-410) as shown
below.
Front side
④15m m
②15m m
Rear side
© 2018 TOSHIBA TEC CORPORATION All rights reserved
1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
The larger the value is, the larger the reproduction ratio in the
primary scanning direction becomes. (0.1%/step)
Acceptable values: 0 to 255 (Default: 128)
③15m m
Center position
(top-bottom and left-right symmetric)
①15m m
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-31
Remarks
⑦15m m
⑧15m m
⑥15m m
⑤15m m