Toshiba e-STUDIO2010AC Imaging Manual page 28

1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
• After adjusting the fusing temperature, perform automatic calibration.
Refer to step (1) in "1.1 To Obtain a Darker Image".
<Hint>
• The smaller the setting value, the lower the fusing temperature becomes. It is usually
recommended that the setting value be decreased in order to suppress roughness on the
high-density area of the image. Adjust the value within the range of the recommended values
while checking the image carefully because if it is too small, insufficient fusing may occur.
After setting the value, print and check the image quality.
If further image quality adjustment is necessary, go to step (3).
(3) Check the life of the consumables (particularly the drum and transfer belt unit) and replace them, if
necessary.
• When replacing any consumable, use steps (a) to (b).
(a) Enter the PM support mode. Reset the counter corresponding to the replaced consumable
part to "0".
For further information regarding the PM support mode, refer to the Service Manual.
(b) Perform automatic calibration.
For further information regarding the procedures, refer to procedure (1) in "1.1 To Obtain a
Darker Image".
• After replacing any consumable, remember to reset the counter by making it correspond to "0".
Otherwise, it may cause a loss in MFP performance, including degradation in the image quality
and a reduction in the life of the consumables.
 Caution after the adjustment
After the fusing temperature was adjusted in step (2) above, printing interruption may occur due to
improper fusing temperature. Therefore adjust the value carefully. If you want to change the conditions
for printing interruption, change the value of the [08] code [5409] (abnormality process starting
temperature setting / recycled paper). For the setting values, refer to the Service Manual.
 Remarks
• Enter the value mentioned in the procedures or one within the recommended value range for the
adjustment. Otherwise, it may cause a loss in MFP performance, including degradation in the image
quality and a reduction in the life of the consumables.
• The desired image quality may not be obtained, depending on the type of paper used. In this case, use
the recommended paper and then print or adjust the image quality.
• If an image problem occurs when you use the other paper type, temporarily set the values of the [05]
codes [2934] to [2937] (bias offset) and [08] codes [5293] to [5294] (fusing temperature during printing)
back to the default ones. Then perform the adjustment again.
• When replacing any consumable, refer to the relevant information in the Service Manual.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
1-16