Toshiba e-STUDIO2010AC Imaging Manual page 317

(b) Select [05 ADJUSTMENT MODE]. Change the values for code [9104] and [9107] to adjust the
image quality and resolution of a background.
[05] code
05-9104
05-9107
• Changing the value provides the effects below. Enter the value within the recommended
value range. Otherwise, it may cause a loss in MFP performance, including degradation in
the image quality.
Set a smaller value: High compression (small file size), low image quality, and high scanning
speed
Set a later value: Low compression (large file size), high image quality, and low scanning
speed
To leave the color of text as it is
Use steps (a) to (b) to perform the adjustment.
(a) Turn the original and place it. Or when scanning the original, press [Scan Setting] on the
Control Panel. Change the "Rotation" option to turn the original.
After changing the "Rotation" option, scan the original and check the scanned-in image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(b) When scanning the original, press [Scan Setting] on the Control Panel. Press [-] to decrease
the sharpness intensity.
• Decrease the sharpness intensity by 1 step from the current value.
To eliminate the background density
When scanning the original, press [Scan Setting] on the Control Panel. Press [
the background density.
After decreasing the background density, scan the original and check the scanned-in image quality.
Only if the user's desired image quality is still not obtained after the above procedure has been
performed, scan the original in JPEG or PDF.
 Caution after the adjustment
The adjustment may possibly cause blurred text, noise or vary the hues of areas. Therefore, carefully
perform the adjustment, while checking the scanned-in image quality.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Recommended value
5
1 or 2
5-11
5.Scanning-specific Adjustments
Acceptable value range
0 to 10
0 to 3
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Default
5
1
] to decrease