Toshiba e-STUDIO2010AC Imaging Manual page 85

• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted. The density of the highlighted area will vary, if the
low or middle density area is mainly adjusted. Adjusting the subcode 2 allows you to adjust the
high density area. But it will not affect the highlighted area. Therefore, never change the value for
the high density area.
Subcode Area where the density is adjusted
0 Low density area
1 Middle density area
(5) By switching to the highlight reproducibility enhancement setting, the highlight can be adjusted by
changing the color reproducibility.
(a) Select [08 SETTING MODE] and change the setting value for the code [7614]. Usually, set "1"
(Text/Photo base).
(b) Select [05 ADJUSTMENT MODE] and change the setting value for the code [7690].
Recommended
[05] Code
value
05-7690
• The level of the highlight reproducibility will become higher in the order of the setting value 0 < 1 <
4. In addition, if the setting value "1" is set, not only the highlight reproduction is changed but also
the entire color tone is altered against the default one.
 Caution after the adjustment
The adjustment may possibly provide an excessively dark background. Therefore, carefully perform the
adjustment, while checking the copy image.
 Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may
cause a loss in MFP performance, including degradation in the image quality and a reduction in the life of
the consumables.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Acceptable
value range
4 0 to 6
2-31
2.Copier-specific Adjustments
Default Remarks
0: Same as Text/Photo, printed
image, text, map (text priority) mode
1: Same as Photo mode
0
4: The highlight reproduction
becomes more emphasized than the
one specified in the setting value "0".
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC