Toshiba e-STUDIO2010AC Imaging Manual page 27

Paper type
Front
Full color
Back
Front
Black
Back
• "Front" refers to the printed side in the simplex mode or the side that is delivered facing
upwards in the duplex mode.
"Back" refers to the printed side that is delivered facing downwards in the duplex mode.
• After adjusting the transfer roller bias output, perform automatic calibration.
Refer to step (1) in "1.1 To Obtain a Darker Image".
<Hint>
• The larger the setting value is, the more the transfer voltage increases. It is usually
recommended that the setting value be increased when you print on thick paper or paper with
asperities on its surface. On the other hand, the setting value should be decreased when you
print on thin paper.
After setting the value, print and check the image quality.
If further image quality adjustment is necessary, go to step (b).
(b) Select [08 SETTING MODE]. Change the value of the code [5293] to adjust fusing
temperature in the recycled paper mode. (In this step fusing temperature is adjusted to print
the high density area of the image most clearly.)
Model Adjustment
e-STUDIO
Black
Center
2010AC/
thermistor
2510AC
Black
e-STUDIO
2515AC/
3015AC/
Center
3515AC/
thermistor
4515AC/
5015AC
© 2018 TOSHIBA TEC CORPORATION All rights reserved
1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
[05] code Subcode
Recycled
05-2934
paper
Recycled
05-2935
paper
Recycled
05-2936
paper
Recycled
05-2937
paper
Paper
[08] code Subcode
type
Recycled
08-5293
paper
Color
Recycled
08-5293
paper
Color
1-15
Recomm Acceptabl
ended
value
7 2 to 8
7 2 to 8
7 2 to 8
7 2 to 8
Recommended
value
0
9 to 11
1
0
9 to 11
1
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
e value Default
range
0 to 10 5
0 to 10 5
0 to 10 5
0 to 10 5
Acceptable
value Default
range
10
0 to 16
11
8
9:
e-STUDIO
2515AC/
3015AC/
0 to 22
3515AC
10:
e-STUDIO
4515AC/
5015AC