Toshiba e-STUDIO2010AC Imaging Manual page 75

(2) Perform color balance adjustment or RGB adjustment to adjust the tint of colors in general.
• For further information regarding the adjustment procedures, refer to procedure (3) in "2.3 To
Closely Match the Color Balance of the Original".
Fine adjustment cannot be made from the control panel. Therefore, in order to apply further fine
image quality adjustment, perform step (3).
(3) Select [05 ADJUSTMENT MODE] and arrange the color balance by changing the setting values for
the codes from [7960] to [7987] to adjust the density for each color.
Color to adjust Original mode [05] code Subcode
Y (Yellow)
M (Magenta)
Text/Photo
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
Text
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
Printed Image
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
Photo
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
Map
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
User Custom
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
Red Seal Color
C (Cyan)
K (Black)
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
• The value for the code corresponding to the original mode (Text/Photo, Text, or Printed Image) will
affect the copy image quality in the Full color mode and the Auto Color mode.
• The setting value "25" corresponds to one step in the adjustment on the control panel.
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted.
Subcode
0
1
2
© 2018 TOSHIBA TEC CORPORATION All rights reserved
05-7960
05-7965
05-7970
05-7975
05-7961
05-7966
05-7971
05-7976
05-7962
05-7967
05-7972
05-7977
05-7963
05-7968
0 / 1 / 2
05-7973
05-7978
05-7964
05-7969
05-7974
05-7979
05-7980
05-7981
05-7982
05-7983
05-7984
05-7985
05-7986
05-7987
Area where the density is adjusted
Low density area
Middle density area
High density area
2-21
2.Copier-specific Adjustments
Recommended
value
Set a value larger
than 128 to increase
the density.
Set a value smaller
than 128 to decrease
the density.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Acceptable
Default
value range
0 to 255 128