Toshiba e-STUDIO2010AC Imaging Manual page 34

1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
(C). To stabilize the image quality on Low/Middle density in pictures (when interrupting jobs and
starting the Full Mode at every 250 pages)
Code to set
number of
pages
Full IQC 08-2509
Short IQC 08-2497
Printing
08-9199
interrupted
*8.When the number of times in the Full Mode increases, more toner is consumed.
(D). To emphasize performance (for less use of the Short Mode)
Code to set
number of
pages
Full IQC 08-2509
Short IQC 08-2497
Printing
08-9199
interrupted
*9.When the Full Mode and the Short Mode are set simultaneously, the former has a priority.
If you never want to start the Short Mode, set "1" (Disabled) to code 08-2495. (0: Enabled)
<Notes>
• Set the value in consideration of users' requests and the total number of pages output in a day. To
maintain the optimal image quality, it is recommended to start the Short Mode at least two or three
times a day.
• Do not set the number of output pages smaller than 50 for codes 08-2509 and 08-9199 because
this affects the life of consumables such as a cleaning blade.
• Changing this setting improves the stability of the image quality. However, a long application of
this change affects the life of consumables. It is recommended to make only a minimal change
and then return to the default value immediately.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Setting
value *8
250 The control starts after every 250 pages.
The control starts after 50 pages have been output, or
100
when a job is interrupted after every 250 pages.
250
Setting
value *9
1000 The control starts after every 250 pages.
The control starts only when a job is interrupted after 500
500
pages have been output.
1000
1-22
Starting conditions
Starting conditions
© 2018 TOSHIBA TEC CORPORATION All rights reserved