Toshiba e-STUDIO2010AC Imaging Manual page 68

2.Copier-specific Adjustments
• After changing the value, perform automatic calibration.
Refer to step (1) in "1.1 To Obtain a Darker Image" to perform automatic calibration.
If further adjustments are necessary after performing step (8), you can repeat steps (1) to (7).
When repeating these steps, however, adjust the value while checking the copy image carefully.
(10) Select [08 SETTING MODE]. Change the value for subcode 0 to 7 of code [2620].
Color to
Original mode [08]code Subcode
adjust
Plain paper
Y
Thick paper
M
Recycled
C
paper
K
Thin paper
Y Thick paper 1/
2/3/4
M
Special paper
C
1/2/3
Envelope
K
Transparency
(OHP film)
 Caution after the adjustment
The adjustment may possibly cause an increase in the amount of toner used, moiré, blurred text (small,
dark text blurred), faint text (fine outlines of text shredded) diminished photo images or gradational
images (less accurate reproducibility of halftones), or in some consumption conditions of consumables,
background fogging or a decrease in the amount of developer material (carrier streaks). Therefore,
carefully perform the adjustment while checking the copy image.
 Remarks
• Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may
cause a loss in MFP performance, including degradation in the image quality and a reduction in the life
of the consumables.
• If you perform only step (9) above (changing the setting value of code [08-2548]) as an image quality
adjustment for a certain color, it may cause an extra increase or decrease in the amount of the toner
used for this color compared with that for the other colors, or it may create a difference in the
reproducibility of halftones.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Recommended
0
1
08-2620
2
3
Set a value larger
than 15 to make the
4
text darker and
5
clearer.
6
08-2620
7
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-14
Acceptable
value range value
8-36
Default
15