Toshiba e-STUDIO2010AC Imaging Manual page 233

PCL XPS
PS
By performing this adjustment, the lines of the text will be made thicker and clearer or thinner or finer.
• This adjustment can be made applicable to all colors by selecting the corresponding subcode.
However, it is recommended to enter the same setting value for all the subcodes unless otherwise
required.
Setting item
M
Potential on
printing white text /
Correction setting
• To check the amount changed with this setting, it is recommended to set the value at "3" or "4" first
to decrease it, and then to set the value at "8" or "9" first to increase it. Then check the copy image
and increase or decrease the value further so that the image will be adjusted finely.
• After changing the value, perform automatic calibration.
• Refer to step (1) in "1.1 To Obtain a Darker Image" to perform automatic calibration.
 Caution after the adjustment
• Performing this adjustment on thin lines may not give satisfactory results. In this case, it is
recommended to perform the adjustment in conjunction with "3.6.1 To Reduce Jaggies on Text and
Lines (Improvement by means of halftone adjustment)".
• In some consumption conditions, background fogging or a decrease in the amount of developer
material (carrier streaks) may occur. Therefore, carefully perform the adjustment while checking the
printed image.
 Remarks
If you perform only step (2) above (changing the setting value of the code [08-2548]) as an image quality
adjustment for a certain color, it may cause an extra increase or decrease in the amount of the toner
used for this color compared with that for the other colors, or it may create a difference in the
reproducibility of halftones.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Mac
[08] code Subcode
Y 0
1
08-2548
C 2
K 3
3-73
3.Printer-specific Adjustments
Recommended value
To make the outline of
text thicker and clearer:
Set a value smaller than
6.
To make the outline of
text thinner and finer:
Set a value larger than 6.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Acceptable
Default
range value
0 to 12 6