When Adjusting The Image Quality Of The Full Color Mode - Toshiba e-STUDIO2010AC Imaging Manual

2.24.2

When adjusting the image quality of the Full color mode

Both the service technician and the user can use all steps of this adjustment.
<Notes>
• This adjustment is available when the Text/Photo mode is selected for the original mode for full color
copying.
• Normally, the use with the factory default setting (Disabled) is recommended since the adjustment
may decrease the reproducibility of fine characters.
(1) Press [Image] tab on the Copy mode and then press [ADF Noise Reduction].
Change the setting value of the noise reduction level.
Setting value
None
Low
Middle
High
After changing the setting value, perform printing and check its image quality.
 Caution after the adjustment
Nothing in particular
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Description
The noise reduction function is disabled.
The noise reduction level is low.
The noise reduction level is middle.
The noise reduction level is high.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-97
2.Copier-specific Adjustments