To Closely Match The Color Balance On The Monitor - Toshiba e-STUDIO2010AC Imaging Manual

3.Printer-specific Adjustments
3.4.2

To Closely Match the Color Balance on the Monitor

Before adjustment
The color balance as viewed on the
monitor looks different from the printout.
 Explanation
The color balance on the printouts is initially programmed to provide the maximum color saturation within
the range of colors reproducible in printing. In general, colors, which can be reproduced, vary, depending
on whether they are reproduced on the printout or on the monitor (or depending on whether they are
reproduced in "ink" or with the "light"). Consequently, the color balance on the printout cannot be
perfectly matched with the one on the monitor. Change the "Image Quality Type" option, in order to
closely match the color balance on the printout with the one on the monitor, at a user's request.
• This adjustment will be effective in closely matching the color balance on the printout with the one on
the monitor, if the sRGB is selected as a color space. Therefore, remember that it may not be matched
with the color balance on the monitor, which does not support sRGB or if a color space other than
sRGB is selected.
On commercially available monitors, sRGB is not selected as a color space by default.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
As viewed on the monitor
3-44
After adjustment
The color balance of the printout is
closely matched with the one on the
monitor
© 2018 TOSHIBA TEC CORPORATION All rights reserved