Huawei NetCol8000-A Series User Manual page 109

NetCol8000-A(050, 100) In-room Air Cooled Smart
Cooling Product
User Manual
Parameter
Communic
ation
address
----End
Setting Parameters for Modbus TCP
Step 1 On the home screen, choose Settings > Comm Settings > Modbus Settings.
Figure 5-8
Step 2 Set parameters for Modbus TCP.
Table 5-5 Modbus TCP parameter settings
Parameter
Link mode
Client
encryption
Server
encryption
NMS IP
address
NMS port
number
----End
Issue 12 (2020-10-28)
Setting Setting Method
1–255 Set the communication address of the smart
cooling product as planned. The EMS
communicates with the smart cooling product
through this address, and the communication
addresses of two smart cooling products
connecting to the same EMS must be unique.
is displayed.
Setting Setting Method
Server, ● If you set Link mode to Server, the smart
Client,
Server and
client
● If you set Link mode to Client, the smart
● If you set Link mode to Server and client, the
Enable, This parameter is configurable when Link mode is
Disable set to Client.
Enable, This parameter is configurable when Link mode is
Disable set to Server.
N/A Enter the actual IP address of the EMS. IP addresses
of the display panel, EMS client, and EMS server
must be unique. This parameter is configurable
when Link mode is set to Client.
N/A It is recommended that you retain the default
value. If you need to change the value, enter a
value as required. This parameter is configurable
when Link mode is set to Client.
Copyright © Huawei Technologies Co., Ltd.
cooling product, as a server, supports two client
connection and establishes communication.
cooling product, as a client, can connect to a
remote server and establish communication.
smart cooling product, as a server, supports two
client connection and establishes
communication. In addition, the smart cooling
product, as a client, can connect to a remote
server and establish communication.
5 ACC Introduction
100