How To Manually Clear Alarms - Huawei NetCol8000-A Series User Manual

NetCol8000-A(050, 100) In-room Air Cooled Smart
Cooling Product
User Manual
Procedure
Step 1 After you have entered the home screen, choose Maint > USB Operations >
Software Upgrade, and check whether you can perform the upgrade.
●
●
Step 2 If The e-label board is not connected or the e-label is incorrect. Please
connect or replace the e-label board. is displayed, power off the system,
reconnect or replace the E-label board, and then power on the system.
Step 3 If the fault persists, contact Huawei technical support.
----End

5.13 How to Manually Clear Alarms

Context
●
●
Procedure
Step 1 On the home screen, tap Alarms > Query Act. Alarms > Comp HP lock. The
alarm information is displayed, as shown in
Figure 5-50 Manually clearing the alarm
Step 2 Tap Clear. A dialog box for confirming clearance is displayed.
Step 3 Tap Yes. The Command triggered successfully. message is displayed.
Step 4 Tap OK.
----End
Issue 12 (2020-10-28)
If you can perform the upgrade, upgrade the system version by referring to
the software upgrade guide.
If you cannot perform the upgrade, proceed to
instructions of system prompts.
This topic uses the Comp HP switch lock alarm as an example to describe
how to manually clear alarms.
If you need to manually clear alarms, log in as the Admin or Engineer user.
Copyright © Huawei Technologies Co., Ltd.
5 ACC Introduction
Step 2 by following
Figure 5-50.
133