Epson SC-T5400 Series User Manual page 146

SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Settings item
Error Notice
Paper Size Notice
Paper Type Notice
Roll Paper Setup
Detect Paper Me‐
andering
Print Cutting
Guideline
Cut for Borderless
Print
Quick Cut
Cut Mode
Margin Refresh
Using the Menu
Settings value Explanation
On
Setting this to On will display an error message when the output size or
paper type settings of print jobs sent to the printer differ from those settings
*
in the printer.
Off
On
*
Off
* If On is selected, an error will be displayed in the control panel and printing
On
will stop if the paper is skewed; select Off to disable this feature. On is
recommended in most circumstances as skewed paper may cause the
Off
printer to jam.
On If Auto Cut is Off, you can choose to print (On) or not print (Off) cut lines on
roll paper. Cut lines are not printed if Auto Cut is On or when cut sheets are
*
used.
Off
Note, however, that if the roll width selected with the computer is narrower
than the paper loaded in the printer, cut lines will be printed regardless of
the option selected for Auto Cut.
The setting selected with the printer driver takes priority when the printer
driver is used.
* Select whether to insert a margin and cut twice between pages (Two Cuts)
Two Cuts
or cut once between pages (One Cut) when printing multiple pages with
borderless printing.
One Cut
The setting selected with the printer driver takes priority when the printer
driver is used.
U
* Specify the cutting operation for printing multiple page jobs.
On
Setting this to On will cut the preceding printout when its trailing edge
Off
reaches the cutting position while the next job is being printed. This
shortens the printing time because printing and cutting are done in
tandem.
The details of the cutting operation are the same as One Cut of Cut for
Borderless Print or Single Cut of the printer driver.
U
Setting this to Off will start the next print job after the preceding print job is
fed to its cutting position and cutting is completed.
*
If you want to reduce operation noise during cutting, set Quiet. If Quiet is
Normal
set, the cutting speed is reduced.
Quiet
* Select whether to automatically cut (On) or not cut (Off) the leading edge in
On
order to remove ink stains that may have been left by previous borderless
printing before printing with borders.
Off
"About Roll Paper Cutting" on page 73
"About Roll Paper Cutting" on page 73
146