Epson SC-T5400 Series User Manual page 158

SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Settings item
Wi-Fi Direct
Change Network Name (SC-T5400M Series only)
Change Password
Disable Wi-Fi Direct
Delete Registered Device (SC-T5400 Series/
SC-T3400 Series/SC-T3400N Series only)
Restore Default Settings (SC-T5400M Series only)
Wired LAN Setup
Network Status
Wired LAN/Wi-Fi Status
Wi-Fi Direct Status
Email Server Status (SC-T5400M Series Only)
Print Status Sheet
Connection Check
Using the Menu
Settings value Explanation
Disconnected or disabled
This is displayed in gray. Touch this, and on the next screen touching
Start Setup will display Start Setup. Touch Start Setup to enable
Wi-Fi Direct, and display the SSID and password of the printer.
Connected
Touch to display the printer SSID and password, as well as the number
of connected devices. Touch Change Settings to display Change
Password and other menus.
"Directly Connection Wirelessly (Wi-Fi Direct)" on page 33
U
Change the name of the Wi-Fi Direct connection (SSID) that is used to
connect to the printer to any value. Changing the connection name
(SSID) will disconnect all connected devices. If you change the
connection name, you need to re-connect with the new connection
name (SSID) from the device you want to connect to.
You can change the Wi-Fi Direct password. Changing the password
will disconnect all connected computers and smart devices.
Performing this operation will disconnect all connected computers
and smart devices. To disconnect only a specific device, disconnect
the connection from the device.
Smart device menu item.
When using the Wi-Fi Direct function on a smart device to connect to
the printer, a message is displayed on the printer prompting you to
accept or refuse the connection. If refuse is selected, then subsequent
connection with this device will not be possible. To connect with
devices for which connection has been refused, open this menu, and
delete registered device information.
Restores all Wi-Fi Direct settings to the manufacturer's settings.
This also removes connection information stored by the printer that
was registered using the Wi-Fi Direct feature of the smart device.
Touch to change a wireless LAN connection to a wired LAN
connection. Touch Start Setup to disable the wireless LAN
connection.
"Switching to Wired LAN" on page 32
U
Display current communications status and connection settings such
as IP address, etc.
Display number of connected devices and connection settings such as
SSID.
The current method of authentication and authenticated accounts
are displayed. The settings also can be changed.
Print current network connection detailed information.
Confirm the network status of the printer, and print a network
connection check report. In the event of problems, respond in
accordance with the diagnostics results.
158