Saving Power - Epson SC-T5400 Series User Manual

SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
❏ Avoid locations that are subject to direct sunlight,
excessive heat, or humidity.
❏ Keep cut sheets in their original package after
opening, and keep them in a flat place.
❏ Remove roll paper that is not in use from the
printer. Rewind it correctly and then store it in the
original packaging that came with the roll paper. If
you leave the roll paper in the printer for a long
time, its quality may decline.
Notes on handling printed paper
To maintain long lasting, high quality print results, note
the following points.
❏ Do not rub or scratch print outs. If they are rubbed
or scratched, the ink may peel off.
❏ Do not touch the surface of print outs. The ink may
peel off.
❏ Make sure the print outs are completely dry before
folding of stacking; otherwise, the color may change
where they touch (leaves a mark). These marks will
disappear if they are separated immediately and
dried; however, they will remain if not separated.
❏ If you put the print outs in an album before they are
completely dry, they may be blurred.
❏ Do not use a dryer to dry the print outs.
❏ Avoid direct sunlight.
❏ Prevent color distortion while displaying or storing
the print outs by following the instructions in the
paper's documentation.
Introduction
Note:
Typically, print outs and photos fade over time (color
distortion) due to the effects of light and various
constituents in the air. This also applies to Epson special
media. However, with the correct storage method, the
degree of color distortion can be minimized.
❏ See the documentation supplied with Epson special
media for detailed information on handling the
paper after printing.
❏ The colors of photos, posters, and other printed
materials appear different under different lighting
conditions (light sources
from this printer may also appear different under
different light sources.
* Light sources include sunlight, fluorescent light,
incandescent light, and other types.

Saving Power

The printer enters sleep mode or turns off automatically
if no operations are performed for a set period. You can
adjust the time before power management is applied.
Any increase will affect the product's energy efficiency.
Please consider the environment before making any
change.
Sleep mode
The printer enters sleep mode when there are no errors,
no print jobs being received, and no control panel or
other operations performed. When the printer enters
sleep mode, the control panel's screen turns off and the
internal motors and other parts switch off to consume
less power.
Sleep mode is exited if a print job is received or the
screen of the control panel is touched.
You can set the time it takes for the printer to enter sleep
mode. At default settings, the printer enters sleep mode
if no operations are performed for 15 minutes. The time
it takes for the printer to enter sleep mode can be
changed in the Basic Settings menu.
"General Settings - Basic Settings" on page 143
U
Note:
When the printer enters sleep mode, the control panel's
screen goes blank as if the power has been turned off, but
the P light remains lit.
24
*
). The colors of print outs