Epson SC-T5400 Series User Manual page 202

SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
The color is not exactly the same as
another printer.
Colors vary depending on the printer type
o
due to each printer's characteristics.
Because inks, printer drivers, and printer profiles are
developed for each printer model, the colors printed
by different printer models are not exactly the same.
You can achieve similar colors with the same color
adjustment method or the same gamma setting by
using the printer driver.
"Correct color and print" on page 76
U
The print is not positioned properly
on the media.
Have you specified the print area?
o
Check the print area in the settings of the application
and the printer.
Is the Document Size setting correct?
o
If the option selected for Document Size in the print
driver or Paper Size driver does not match the paper
loaded in the printer, the print may not be in the
correct position or some of the data may not be
printed. In this case, check the print settings.
Is the paper skewed?
o
If Off is selected for Detect Paper Meandering in the
Printer Settings menu, printing will continue even if
the paper is skewed, resulting in printing outside of
the print area. In the Printer Settings menu, set Detect
Paper Meandering to On.
"General Settings - Printer Settings" on
U
page 145
Is the roll paper margin set wide?
o
If margins narrower than the margins set in the roll
paper Advanced Media Setting - Top/ Bottom
Margins menu are set in the application software,
then priority is given to the printer settings.
"Roll Paper menu" on page 136
U
Problem Solver
Lengths differ between the print
results and print data
If you want to print to roll paper with lengths exactly as
specified in the print data, such as when printing CAD
drawings, make the following adjustments. You will
need a ruler so get one ready before performing this
work.
The length of the paper used for adjustment pattern
printing is approximately 555 mm.
A
Touch the Roll paper information area - Media
Adjust from the Home screen.
B
Touch Paper Feed Adjust - Print length
adjustment - Start.
The adjustment patterns are printed.
C
Measure the distance between the "+" symbols on
the printed patterns with a ruler.
D
Enter the measured length in the screen.
E
Touch OK.
When Print head alignment complete... appears, the
procedure is finished.
The adjustment results are saved as settings of the
currently selected paper type.
Vertical ruled lines are misaligned.
Has Print Head Alignment been carried out?
o
Confirm that paper type settings that match the paper
are selected, and perform Print Head Alignment.
"Setting Loaded Paper" on page 44
U
"Optimizing Paper Settings (Media Adjust)" on
U
page 48
202