SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Settings item
Using the Menu
Settings value
Explanation
Oversize
The position at which the margin is added depends on the base output size
setting, as shown below.
❏
❏
When set to Auto
Adds the value selected for page margin (area of
illustration) outside the hard clip area of the PS command of the data
(area of
in the following illustration).
When set to a standard size or user defined size
Adds the value selected for page margin (area of
illustration) outside the size selected for base output size (area of
the following illustration). With the actual output size, the margin
section becomes larger than the selected size (the area of
following illustration).
152
in the following
in the following
in
in the