Epson SC-T5400 Series User Manual page 149

SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Settings item
Paper Suction
Back Tension
Drying Time
Drying Time per
Pass
Drying Time per
Page
Paper Size Check
Auto Cut
Remove Skew
Restore Default
Printing Language
Using the Menu
Settings value Explanation
-4 to +3 It is important to choose the appropriate amount of suction for the paper
used in order to maintain the correct distance between the paper and print
head. Choosing too high a value for thin or soft paper will increase the
distance between the paper and print head too much, causing print quality
to decline or preventing the paper feeding correctly. In such cases, you will
need to lower the paper suction. The lower the setting value, the weaker the
suction power.
*
If there is any wrinkling on the paper during printing, select High or Extra
Auto
High.
Standard
When this is set to Extra High, the following setting is enabled.
High Settings - General Settings - Printer Settings - Paper Source Settings -
Roll Paper Setup - Back Tension 2
Extra High
0.0 to 10.0 seconds Select the time the print head pauses to allow drying after each pass.
* Choose from values between 0.0 and 10.0 seconds. Depending on the paper
(0.0 )
type, the ink may take a while to dry. If the ink blurs on the paper, set a longer
time for drying the ink. Increasing the drying time increases the time
needed to print.
0.0 to 60 minutes Specify how long the printer pauses to allow the ink to dry after printing
* each page; choose from values between 0 and 60 minutes. Depending on
(0.0 )
the ink density or paper type, the ink may take a while to dry. If the ink blurs
on the paper, set a longer time for drying the ink. The longer the drying time,
the more time required for printing.
* Select whether to detect (On) or not detect (Off) the paper width when
On
paper is loaded. Try choosing Off if a paper setting error is displayed even
though the paper is correctly loaded. Note, however, that the printer may
Off
print outside the paper when Off is selected. If it prints beyond the edges of
the paper, the inside of the printer becomes dirty with ink. We generally
recommend using the printer with this set to On.
The changes are applied after the paper is reloaded. Note that they are not
applied if you just change the menu items.
*
Select whether to automatically cut (On) or not cut (Off) using the built-in
On
cutter as each page is printed on roll paper. Set On to automatically cut the
edge if it is not a horizontal cut when paper is loaded.
Off
The setting selected with the printer driver takes priority when the printer
driver is used.
U
*
Select whether to enable (On) or disable (Off) paper skew reduction.
On
Off
Restore the selected Custom Paper settings to default settings.
"Cutting the Roll Paper" on page 38
149