Moving To A Different Location In The Same Building - Epson SC-T5400 Series User Manual

SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
SC-T3400 Series/SC-T3400N Series
❏ Do not tilt the product more than 10 degrees
forward, back, left, or right while moving it. Failure
to observe this precaution could result in the printer
falling over, causing accidents.
❏ Leave the paper basket open when you install the
printer after removing the stand of the SC-T3400
Series and moving it. Otherwise, the paper basket
will not open.
c
Important:
The print head may fail if the environmental
temperature becomes -10˚C or lower.
Eject the ink prior to turning off the power if you
expect to be moving or transporting the printer in an
environment of -10˚C or below.
See the following procedure for detailed
instructions.
"Handling if Transporting/Leaving the Printer
U
in an Environment of -10˚C or Less" on page 231
Moving to a Different Location in
the Same Building
Preparations for Moving
This explains preparations for moving the printer a
short distance, for example within the same building.
See the following section for information on moving the
printer between floors or to another building.
Appendix
"When Transporting" on page 231
U
For models with stands, moving the printer on casters is
possible providing there are no steps or unevenness in
the floor along the route, however pay attention to the
following points.
Caution:
For models with stands, ensure that you abide by the
following points in order to prevent damage from
falling over.
❏ Do not move the printer with casters locked
❏ Avoid areas with steps or unevenness
❏ After moving, ensure the casters are locked
before use
c
Important:
Ensure you move and transport the printer with the
ink cartridges installed. Do not remove the ink
cartridges; otherwise, the nozzles may be clogged
and make it impossible to print, or ink may leak.
A
Remove all paper from the printer.
B
Close all covers on the printer. For models with
stands, close the paper basket.
C
Turn off the printer, and unplug all cables,
including the power cord and LAN cables, etc.
D
For models with stands, release the locks on the
casters.
Operations after Moving
This explains operations to prepare for use after moving
the printer.
A
Connect the power cable, and turn the printer
on.
B
Check for print head nozzle clogging, and if these
are clogged, carry out print head cleaning.
"When you want to unclog the print head"
U
on page 199
230