Removal - Siemens SINAMICS S120 Manual

3. Press the latching cams on the BOP20 together,
and push the BOP20 straight in until you hear it
engage.
4.6.4

Removal

Please note the following information when removing the BOP20 from the Control Unit:
1. Simultaneously press the latching cams on the BOP20.
2. Always withdraw the BOP20 straight out (without skewing it). Never withdraw the BOP20 by
pulling it at its lower edge, as this could damage the interface at the rear.
Figure 4-20
Control Units and additional system components
Equipment Manual, 06/2020, 6SL3097-5AH00-0BP2
Incorrect removal of the BOP20 from a CU320-2 DP (example)
Control Units and operating elements
4.6 Basic Operator Panel BOP20
CU320-2 DP with BOP20 installed
93