Meaning Of The Led - Siemens SINAMICS S120 Manual

Hub Modules
7.3 DRIVE-CLiQ Hub Module DMC20
7.3.3

Meaning of the LED

Table 7-4 Description of the LEDs on the DRIVE-CLiQ Hub Module DMC20
LED Color
READY –
Green
Orange
Red
Green/red
Green/
orange
or
Red/
orange
202
Status Description, cause
Off The electronics power supply is missing or outside the permis‐
sible tolerance range.
Continu‐ The component is ready for operation. Cyclic DRIVE-CLiQ com‐
ous light munication is taking place.
Continu‐ DRIVE-CLiQ communication is being established.
ous light
Continu‐ This component has at least one fault.
ous light
Note:
LED is controlled irrespective of the corresponding messages
being reconfigured.
Flashing Firmware is being downloaded.
light 0.5
Hz
Flashing Firmware download is complete. The system waits for POWER
light 2 Hz ON.
Flashing Component recognition via LED is activated (p0154 = 1).
light
Note:
2 Hz
Whether the LED flashes green/orange or red/orange depends
on the status the LED had during activation (setting parameter
p0154 to "1").
Remedy
–
–
–
Remove and acknowl‐
edge the fault.
–
Carry out a POWER ON.
–
Control Units and additional system components
Equipment Manual, 06/2020, 6SL3097-5AH00-0BP2