NEC DSX Software Manual page 256

Line Groups
Programming
-
1. Verify the Line Group configurations.
In 3201-[01-64]: Line Group (page 833), be sure lines are properly assigned to their respective groups.
3.
- A line can be in more than one group.
2. Make sure the extension has access to the Line Groups.
1. In 2131-[01-64]: Line Access (page 763), enter 2 (outgoing) or 3 (full) for each line the extension should
be able to access.
2. In 2133-[01-64]: Line Group Access (page 765), enter Yes for each group the extension should be able to
access.
3. Verify that the dialing plan setup allows dialing Line Groups (90-98).
1. In 1301-[01-10]: Function Type (page 620) for the digit 9, enter 3 (Line Group).
2. In 1301-[01-10]: Expected Number of Digits (page 620) for the digit 9, enter 2 .
- To provide Line Group Routing (dial 9), change this entry to 1.
Other Related Features
Features
Loop Keys (page 233)
Switched and Fixed Loop Keys use the system's Line Groups.
Line Group Routing (page 223)
With Line Group Routing enabled, extension users can press INTERCOM and dial 9 to place outgo-
ing calls.
IntraMail Features
None
Operation
• By default, pressing Intercom and dialing 911 or lifting the handset and dialing 911 will not call emergency services.
To place a call over a Line Group:
1. Lift the handset and press INTERCOM .
Dial the Line Group code (90-98).
2.
• If you hear busy tone and your extension has Line Queuing, you can dial 2 to queue for a line to become free.
If you hang up, the system converts the queue to a Line Callback.
• If you hear dial tone after dialing 9, Line Group Routing is enabled.
Dial your outside number.
3.
226 ◆ Features
Using Line Groups
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
DSX Software Manual