1602-Outgoing Call Timers; 1602-01: Interdigit Timer; 1602-02: Line Response Timer; 1602-03: Dialtone Detect Timer - NEC DSX Software Manual

1602-Outgoing Call Timers

Description
Use this program to adjust timers that affect outgoing calls.
Options

1602-01: Interdigit Timer

(Interdigit Time)
Use this option to set the Intercom interdigit time. When an extension user places a call, they must dial each
succeeding digit within this interval.
Features
• Central Office Calls, Placing (page 78)
• Directory Dialing (page 131)
• Intercom (page 211)
IntraMail Features
• None
Options
• 1-9999
Default
• 6 seconds

1602-02: Line Response Timer

(Line Response)
When the system sends a line seize message to the ATRU/COIU PCB, it waits this interval for a response
from the line PCB. If the system gets no response within this interval, it marks the line as defective. Be sure
the value you enter is compatible with the local telco. If you set this value too short, the system may mark
properly functioning lines as defective. If too long, defective lines may be left in service.
Features
• N/A
IntraMail Features
• None
Options
• 4-1020
Default
•
100

1602-03: Dialtone Detect Timer

(Dialtone Detect)
When the system seizes a line to place a Speed Dial call, it waits this interval for dial tone before outdialing
the call. The system requires that the first dial tone be at least 5 seconds long and the second dial tone to be
at least 2.5 seconds long. Be sure the value you enter is compatible with the local telco. If you set this value
too short, the system may not seize properly functioning lines. If too long, there will be too long a delay
before the system skips over a defective line.
Features
• Speed Dial (page 315)
IntraMail Features
• None
DSX Software Manual
seconds
in 100 mS intervals (e.g., 10 = 1 second, 100 = 10 seconds).
(10 seconds)
16xx-Timers
160x-Feature Timers
1602-Outgoing Call Timers
System Options: 1001-1702 ◆ 671