NEC DSX Software Manual page 33

Initial Startup Programming
1. Enter the programming mode.
From any display telephone:
1.
- Press
- Enter the system password +
The system passwords are:
2.
- 632379 (NECDSX)
-
9999
-
0000
3. See System Programming Password Protection (page 336) for more.
2. Assign the correct circuit type to each of your installed lines.
1. In 3101-01: Line Type (page 809), assign the correct circuit type for each line. Analog line types are:
-
51
-
52
By default, each extension has full incoming and outgoing access to each line. To change this
3.
assignment:
If yes, in 2131-[01-64]: Line Access (page 763), change each extension's line access as required:
1.
- 0
-
1
- 2
- 3
2. Using 902x-Copy (page 921) may save you time.
By default, all extensions 300-315 ring immediately day and night for on lines 1-12. To change
4.
this assignment:
1. In 2132-[01-64]: Line Ringing (page 764) set the ringing option for each extension:
- 0
-
1
- 2
- 3
2. Using 902x-Copy (page 921) may save you time.
5. To change the default system passwords:
1. Turn to System Programming Password Protection (page 336) to learn more about system passwords.
6. To return the system to the factory installed (default) programming:
1. Turn to 901x-Initialize (Initialize Utilities) (page 917) to learn more about system initialization.
DSX Software Manual
INTERCOM + Dial #*#*
HOLD
for Installer (level 3)
for System Administrator 2 (level 2)
for System Administrator 1 (level 1)
for loop start DTMF
for loop start DP
for no access
for incoming access only
for outgoing access only
for full access
for lamp only (no ringing) day and night
for day and night ringing
for night ringing only
for delay ringing day and night
Default Feature Setup
Introduction ◆ 3