Motorola G24 Guide Developer's Manual page 110

Call Control
Command
+CHLD=<n>
Command
Type
Test
The following table shows the +CHLD parameters.
<Parameter>
<n>
3-26
disconnected or separated (removed from the MTPY call, but remain connected to the
served mobile subscriber).The maximum number of remote parties is 5.
In this command, the term CALL refers to a single or MTPY call.
A single Active call is considered a MTPY call with one call index numbered as 1.
If the call is terminated:
OK (approve request was submitted)
NO CARRIER
If the call state is changed (link, split, from active to hold, and so on):
OK (approve request was done)
If the call is terminated and another call is answered:
OK (approve request was submitted)
NO CARRIER
OK (call answered and is now connected)
Syntax
+CHLD=? +CHLD: (list of supported <n>s)
OK
Table 3-10: +CHLD Parameters
Call hold operation:
0 - Releases all held calls
OR
Sets User Determined User Busy for a waiting call
1 - Releases all active calls and accepts the held or waiting call
1x - Release specific call x, where x is the serial number of a call participating in an
active MTPY call.
2 - Places all active calls on hold and accepts the held or waiting call
2x - In the case of an active MTPY call, places all active calls on hold, except for call
x. Call x remains active.
3 - Adds a held call to the conversation - MTPY
Note: "Held calls" or "active calls" means a held or active single or MTPY call. There
cannot be two or more different held/active single/MTPY calls.
AT Commands Reference Manual
Response/Action
Response/Action
The Test command returns <n> values
supported by the G24 to the terminal
Description
Remarks
December 31, 2007