Q, Result Code Suppression - Motorola G24 Guide Developer's Manual

Modem Configuration and Profile
The following table shows the V parameters.
<Parameter>
<value>
Example
ATV?
V: 1
OK
ATV0
0
ATV7
4
ATV1
OK
ATV7
ERROR

Q, Result Code Suppression

This command determines whether to output the result codes. Information text transmitted in
response to commands is not affected by the setting of this parameter.
Command Type
Set
Read
Test
3-274
Table 3-181: V Parameters
0 Transmits limited headers and trailers, and numeric text.
1 Transmits full headers and trailers, and verbose response text.
The default value is 1.
Syntax Response/Action
ATQ<value> OK
or:
+CME ERROR: <err>
ATQ? <current value>
AT Commands Reference Manual
Description
Remarks
The set commands sets whether or not
to output result codes.
The Read command reads the current
setting for result code suppression.
The Test command for Q is not
defined, and therefore is not supported
by the G24. The G24 returns an error.
December 31, 2007