Motorola G24 Guide Developer's Manual page 56

AT Commands Summary
AT Command
H
A
+CRC
RING
+CRING
+CLIP
+CCWA
+CHLD
+CCFC
+CLIR
+CBST
O
+CHUP
+CSNS
+MDC
+CTFR1
+MCST
+TCLCC
+MNTFY
+MFIC
+MHUP
1-22
Table 1-1: AT Commands (Cont.)
Description
This command hangs up, or terminates a particular call.
This command answers an incoming call, placing the G24 into the
appropriate mode, as indicated by the RING message.
This command controls whether to present the extended format of
the incoming call indication.
This unsolicited event is received when an incoming call (voice,
data or fax) is indicated by the cellular network.
This unsolicited event indicates the type of incoming call.
This command controls the Calling Line Identity (CLI) presentation
to the terminal when there is an incoming call.
This command controls the Call Waiting supplementary service,
including settings and querying of the network by the G24.
This command controls the Call Hold and Multiparty Conversation
supplementary services.
This command controls the call-forwarding supplementary service.
This command enables/disables the sending of caller ID information
to the called party, for an outgoing call.
This command handles the selection of the bearer service and the
connection element to be used when data calls are originated.
This command returns a phone to the Online Data mode and issues a
CONNECT or CONNECT <text> result code.
This command causes the G24 to hang up the current GSM call.
This command handles the selection of the bearer or teleservice to
be used when a mobile terminated single numbering scheme call is
established.
This command enables you to select the desired messages to be
displayed upon connection of a voice call with a remote party.
This command terminates an incoming call and diverts the caller to
the number previously defined in CCFC, or to a voice mail if one
exists for the subscriber.
This command displays the current state of the call processing, and
also enables/disables the unsolicited indication of any change in the
call processing state.
This command displays a list of all current G24 calls and their
statuses, and also enables/disables the unsolicited indication of the
call list.
This command enables/disables unsolicited report of NOTIFY
indication arrived from the NW.
This command instructs the G24 to query or set Filtering
Incoming Calls parameters.
This command Hung UP call(s) and report specific cause to the NW.
AT Commands Reference Manual
Page
Page 3-17
Page 3-19
Page 3-19
Page 3-19
Page 3-19
Page 3-21
Page 3-23
Page 3-25
Page 3-29
Page 3-31
Page 3-33
Page 3-34
Page 3-35
Page 3-36
Page 3-38
Page 3-39
Page 3-49
Page 3-51
Page 3-53
Page 3-40
Page 3-42
December 31, 2007