Mrst, Perform Hard Reset; Twus, Wakeup Reason Set - Motorola G24 Guide Developer's Manual

The following table shows the ATS97 parameters.
<Parameter>
<info>
Example
// Connect the antenna
ATS97?
001
ATS97
OK
ATS97=?
ERROR
// Disconnect the antenna
ATS97?
000

+MRST, Perform Hard Reset

The +MRST command enables customer software to perform a hard reset to the G24 unit. This
command provides a software simulation for pressing the power-off button. The command can be
sent to the G24 unit from each of the MUX channels.
Command Type
Set
Example
AT+MRST
OK
// Result - G24 module performs a power down

+TWUS, Wakeup Reason Set

This command is used to set or query the wakeup reason(s).
This command allows selecting one or multiple events to wake the terminal connected to the G24.
When any of the selected events occurs, the G24 asserts the Wakeup Out line to low to wake the
terminal.
December 31, 2007
Table 3-135: ATS97 Parameters
000 The antenna is not connected
001 The antenna is connected
Syntax Response/Action
+MRST OK
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Description
Remarks
The Set command performs a graceful
hard reset to the G24 module.
Note: The Read and Test commands
are not permitted for the
+MRST command.
3-207