S, Bit Map Registers - Motorola G24 Guide Developer's Manual

S, Bit Map Registers

This command reads/writes values of the S-registers. The G24 supports this command for various
S values, according to official specifications (ITU-I, ETSI, or manufacturer specific).
Command Type
Set
Read
Test
December 31, 2007
Syntax Response/Action
ATSn=<value OK
or:
+CME ERROR: <err>
ATSn? <current value of
S-register n>
or:
+CME ERROR: <err>
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
The Set command is allowed for
read/write S-registers, and not allowed
for read-only S-registers.
The Test command for Sn is not
defined by ITU, and therefore is not
supported by the G24. The G24 returns
an error.
3-277