Fax Commands; Fclass, Select Mode - Motorola G24 Guide Developer's Manual

Fax Class 1

Fax Commands

+FCLASS, Select Mode

The G24 facsimile service maintains a parameter for identification and control of facsimile
services, "+FCLASS". When the terminal wants to establish a FAX connection, it must set the
G24 to Service Class 1 operation prior to answering or originating a call. This is done by setting
+FCLASS = 1.
Command
Type
Set
Read
Test
The following table shows the +FCLASS parameters.
Example
AT+FCLASS=?
+FCLASS: 0,1
OK
AT+FCLASS?
+FCLASS: 0
OK
AT+FCLASS=1
OK
3-424
Syntax Response/Action
AT+FCLASS=<n> OK
(Puts the G24 into a
particular mode of
operation.)
+CME ERROR: <err>
AT+FCLASS? +FCLASS: <n>
OK
+CME ERROR: <err>
AT+FCLASS=? (list of supported <n>s)
OK
+CME ERROR: <err>
Table 3-281: +FCLASS Parameters
<Parameter>
<n> 0 Data modem (for example, Recommendation V.25 ter)
1 Service Class 1 fax
AT Commands Reference Manual
Remarks
The Set command sets the G24
facsimile service class from the
available choices.
The Read command reads the current
service class setting of the G24.
The Test command returns a list of
service classes available from the G24.
Description
December 31, 2007