Cmut, Mute/Unmute Currently Active Microphone Path - Motorola G24 Guide Developer's Manual

Audio
The following table shows the +CLVL parameters.
<Parameter>
<level>
Example
AT+CLVL?
+CLVL: 7
OK
AT+CLVL=?
+CLVL: (0-7)
OK
AT+CLVL=3
OK

+CMUT, Mute/Unmute Currently Active Microphone Path

This command is used to mute/unmute the currently active microphone path by overriding the
current mute state.
Command Type
Set
Read
Test
The following table shows the +CMUT parameters.
<Parameter>
<n>
3-234
Table 3-150: +CLVL Parameters
0-7 Manufacturer-specific volume range. 0 is lowest volume (not mute).
The default value is 7.
Syntax Response/Action
+CMUT=<state> OK
or:
+CME ERROR: <err>
+CMUT? +CMUT: <state>
OK
+CMUT=? +CMUT: (list of
supported <state>s)
OK
Table 3-151: +CMUT Parameters
0 Unmute microphone path
1 Mute microphone path
AT Commands Reference Manual
Description
Remarks
The Set command enables/disables
uplink voice muting during a voice
call.
The Read command returns the current
uplink voice mute/unmute state.
The Test command returns the possible
<state> values.
Description
December 31, 2007