Motorola G24 Guide Developer's Manual page 273

Abbreviation/Term
split_pg_cycle
Sync status
T3212
T3314
(PD)TCH ARFCN
Temporary offset
Timeslot
Timing advance
Total downlink LLC
frames transmitted
Total downlink RLC
blocks transmitted
Total uplink LLC
frames transmitted
Total uplink RLC
blocks transmitted
Traffic class
Traffic handling
priority
Tx power
Tx Integer
Uplink coding
scheme from
(Timeslot, Coding
scheme)
Uplink timeslot from
(Timeslot, Coding
scheme)
Vocoder
December 31, 2007
Table 3-122: EFEM Parameters (Cont.)
Number of paging blocks to read on the serving cell in each row of 64 multiframes
(on CCCH or PCCCH). The value can range from 0 to 352.
Provides information about the reporting status of the adjacent cell. Depending on
the status, certain adjacent cell parameters are invalid.
MM location area update timer.
GMM ready timer value (triggering Cell Update procedure).
The ARFCN used for the circuit-switched call or the data transfer. "HOPP" is
displayed when hopping.
Reselection parameter; between 0 and 60 dBm, or "##" for infinite value.
The phone's time slot for the current transmission.
Timing Advance in quarter of bits.
Measured in frames for the current TBF. LLC frame count occurs roughly every 2
seconds. Repeated LLC frames are counted as transmitted frames.
Measured in blocks for the current TBF. RLC frame count occurs roughly every 2
seconds.
Warning: Repeated RLC frames are not counted as transmitted frames.
Measured in frames for the current TBF. LLC frame count occurs roughly every 2
seconds. Repeated LLC frames are counted as transmitted frames.
Measured in blocks for the current TBF. RLC frame count occurs roughly every 2
seconds.
Warning: Repeated RLC frames are not counted as transmitted frames.
Type of application for which the GPRS bearer service is optimized.
Specifies the relative importance for handling of all the GPRS bearer's SDUs
compared to the other bearer's SDUs.
Actual power used by the MS to transmit (in dBm).
Number of slots over which to spread transmission (3 to 50), from SI type 1, 2,
2bis, 3 or 4.
Coding scheme for the uplink data transmission (between 1 and 4). "*" indicates
an unknown coding scheme.
Timeslot used for the uplink data transfer in the current TBF. Information for as
many as four timeslots can be displayed.
Vocoder type.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Description
3-189