Motorola G24 Guide Developer's Manual page 272

Network
Abbreviation/Term
Max bit rate dl
Max bit rate ul
MCC
MNC
MaxTxPWR
Network control order This indicates whether the MS performs GPRS measurement reports and whether,
Network operation
mode
PC_meas_chan
PCR
Penalty time
Power offset
priority_access_thr
Radio priority
Repeated
downlink/uplink
blocks
Repeated
downlink/uplink
frames
Residual ber
RLT
RxLev
Rx_Lev_Full
Rx_Lev_Sub
RxLev access min
RxQual
Rx_Qual_Full
Rx_Qual_Sub
3-188
Table 3-122: EFEM Parameters (Cont.)
Max bit rate for Downlink in KPBS.
Max bit rate for Uplink in KPBS.
Mobile Country Code.
Mobile Network Code.
The maximum power (sent on System Info 3 and PSI 3) that the phone is allowed
to transmit while sending channel request messages.
in the ready state, the reselection is network- or MS-controlled.
Possible values are: 0, 1, 2.
GSM 03.60 network operation mode (1, 2 or 3), from System Info 13.
GPRS flag that indicates whether the downlink measurements for power control
are made on BCCH or PDCH. This is broadcast on System Info 13 rest octets.
Packet Channel Request. Type of request used to set up an Uplink TBF.
Indicates for how long the temporary offset will be applied. The time is calculated
as follows: (Penalty_time+1)*20 in seconds. Value 31 has a special meaning, and
will be displayed differently in the future.
Power offset in dBm.
Indicates the radio priority of the transfer.
Radio priority of the current PDP context.
Number of RLC blocks repeated (either in the uplink or downlink direction,
depending on the screen). Repeated RLC frames are NOT taken into account
when calculating the average throughput.
Number of LLC frames repeated (either in the uplink or downlink direction,
depending on the screen). Repeated LLC frames are taken into account when
calculating the average throughput.
Undetected bit error ratio in the delivered SDUs.
Radio Link Time-out, from System Info 3.
Received signal level, in dBm. This parameter comes in several forms that have
different meanings. Note that RxLev, Rx_Lev_Full and Rx_Lev_Sub are all
calculated by the phone, but RxLev access min is sent by the serving cell (on
System Info 3).
Signal strength of the beacon channel of the serving cell.
Signal strength of the active dedicated channel.
The minimum access RxLev of the cell currently being viewed.
Received signal quality. This parameter may concern two channels.
The base channel (carrying the BCCH).
The dedicated active channel.
AT Commands Reference Manual
Description
December 31, 2007