Fts, Transmit Silence; Frs, Receive Silence - Motorola G24 Guide Developer's Manual

+FTS, Transmit Silence

This command causes the G24 to stop any transmission. The G24 then waits for the specified
amount of time, and sends the OK result code to the terminal.
Command Type
Set
The following table shows the +FTS parameters.
Example
At+fclass=1
OK
Atd035658584
CONNECT 9600
OK
AT+FTS=20
OK

+FRS, Receive Silence

This command causes the G24 to wait for silence and to report back an OK result code when
silence has been present on the line for the specified amount of time. The command terminates
when the required amount of silence on the line is detected or when the terminal sends the G24 a
character other than <DC1> (11h) or <DC3> (13h), which is discarded. In either event, the OK
result code is returned to the terminal.
Command Type
Set
December 31, 2007
Syntax
AT+FTS = OK
<Time>
or:
+CME ERROR: <err>
Table 3-282: +FTS Parameters
<Parameter>
<Time> The time the terminal waits, in 10 millisecond intervals
0-255 Number of milliseconds
Syntax
+FRS = <Time> OK
or:
+CME ERROR: <err>
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
The Set command causes the terminal
to stop any transmission.
Description
Response/Action
The Set command specifies the
amount of time the line must be silent.
Remarks
Remarks
3-425