Mggind, Gsm/Gprs Service Indicator - Motorola G24 Guide Developer's Manual

+MGGIND, GSM/GPRS Service Indicator

This command configures the service indicator line of pin 49 of the 70 pin connector to be GPRS
or GSM registration indicator.
The IO line (pin 49) function according to the current registration state (in service or not) of the
specific service indicator configuration.
Note:
Set
Read
Test
The following table shows the +MGGIND parameters.
<Parameter>
<state>
Example
AT+MGGIND=0
OK
AT+MGGIND?
OK
+MGGIND: 0
AT+MGGIND=1
OK
AT+MGGIND?
+MGGIND: 1
OK
AT+MGGIND=?
+MGGIND: (0-1)
OK
December 31, 2007
IO line (pin 49) out come depends on +MCWAKE configuration.
Command Type
Table 3-132: +MGGIND Parameters
0 GPRS registration indicator.
1 GSM registration indicator.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Syntax
AT+MGGIND=<state>
AT+ MGGIND ?
AT+ MGGIND =?
Description
Response/Action
OK
or:
+CME ERROR: <err>
+MGGIND: <state>
OK
or:
+CME ERROR: <err>
+MGGIND: (list of supported
<state>s)
OK
3-203