Table of Contents
Advertisement
(12) The following screen appears.
TP1 Rev.5
The following screen appears after executing the temporary calibration.
Press the <OK> key to servo control all joints.
Press the <F2> key.
Move the joints except the calibrated joints to the point data position by the motion
command. For an example the motion command will be executed to Joint #1 and
#2 when Joint #4 is calibrated.
Press the <OK> key while gripping the enable switch to execute Go P1.
The following screen appears during Go P1 execution.
Operation 2. TEACH Mode
55
Advertisement
Table of Contents
