Asus DS300j G2 Series User Manual page 104

9. For each of the following items, accept the default or change the settings as required:
• Choose a Stripe size.
64 KB, 128 KB, 256 KB, 512 KB, and 1 MB are available.
• Choose a Sector size.
512 B, 1 KB, 2 KB, and 4 KB are available.
• Choose a Read (cache) Policy.
Read Cache, Read Ahead, and No Cache are available.
• Choose a Write (cache) Policy.
Write Back and Write Through (Thru) are available.
• Check box of Perfect Rebuild Enable / Disable Perfect Rebuild
10. Click the Add button.
The new logical drive appears on the list at the right.
If there is capacity remaining, you can create an additional logical drive.
11. When you are finished, click the Submit button.
The new logical drive or drives appear in the logical drive list.
New logical drives are automatically synchronized. You can access the logical drive during
synchronization.
D l D
eletInG a oGIcal rIve
Caution
If you delete a logical drive, you also delete all the data in the logical drive. Back up any
important data before deleting the logical drive.
This action requires Administrator or Super User privileges.
To delete a logical drive:
1. Click the Storage tab.
2. Click the Logical Drive icon.
3. Click the logical drive you want, then click the Delete button.
4. In the Confirmation box, type the word "
98
" in the field provided and click the Confirm button.
confirm
m l D S
akInG oGIcal rIve ettInGS
To make logical drive settings:
1. Click the Storage tab.
2. Click the Logical Drive icon.
The list of logical drives appears.
3. Click the logical drive you want, then click the Settings button.
4. Make settings changes as required:
• Enter , change, or delete the alias in the Alias field.
Maximum of 32 characters; letters, numbers, space between characters, and underline.
• Choose a Read (cache) Policy.
Read Cache, Read Ahead, and No Cache are available.
• Choose a Write (cache) Policy.
Write Back and Write Through (Thru) are available.
• Check box of Perfect Rebuild Enable / Disable Perfect Rebuild Note that if
Perfect Rebuild is disabled, it cannot be enabled again on the LD.
5. Click the Save button.
For more information, see "Cache Policy" on page <?>.
Note
The Write Cache is always set to WriteThru when Read Cache is set to NoCache.
l l D
ocatInG a oGIcal rIve
This feature causes the drive carrier LEDs to flash for one minute to assist you in locating the physical drives
that make up this logical drive.
To locate a logical drive:
1. Click the Storage tab.
2. Click the Logical Drive icon.
The list of logical drives appears.
DS300f G2 Series User Manual