Managing The Network Connection (Clu) - Asus DS300j G2 Series User Manual

9. Highlight Start and press enter to begin the cloning process.
10. Press any key to continue.
11. Press Y to confirm LUN clone creation.
The cloning progress bar displays.
Note the Target Logical Drive ID. Use this number to identify the LUN clone in the Logical Drive list.
If you chose a redundant RAID level, the LUN clone is automatically synchronized after creation.
After the LUN clone is created, you can manage it like any other logical drive. See Making Spare Drive
Settings (CLU), Locating a Logical Drive (CLU), and Deleting a Logical Drive (CLU).
For users to access the LUN clone, you must map it to an initiator. See "Working with LUN Mapping
(CLU)" on page 156
142
M n
anaGInG the etwork
Network Management deals with network connections and settings for the ASUS DS300f G2's Management
ports. Each Management Port can be configured:
• "Making Virtual Management Port Settings (CLU)" on page 142
• "Making Maintenance Mode Settings (CLU)" on page 143
m v m P
akInG Irtual anaGement ort
The ASUS DS300f G2 subsystem has a virtual management port, enabling you to log into a ASUS DS300f G2
with dual controllers using one IP address.
Before you change settings, please see "About IP Addresses" on page <?>.
You initially made these settings during subsystem setup. You can change them later as required.
Caution
Changing virtual management port settings can interrupt your network connection and require you
to log in again.
M A s
Aking utoMAtic ettings
Automatic settings require a DHCP server on your network. DHCP is currently supported on IPv4 only.
To enable automatic management port settings:
1. From the Main Menu, highlight Network Management and press Enter .
2. Highlight the protocol family (IPv4 or IPv6) you want and press Enter .
3. Highlight Network Settings and press Enter .
4. Highlight DHCP and press the spacebar to toggle to Enabled .
5. Press Control-A to save your settings.
M M s
Aking AnuAl ettings
1. From the Main Menu, highlight Network Management and press Enter .
2. Highlight the protocol family (IPv4 or IPv6) you want and press Enter .
3. Highlight Network Settings and press Enter
4. Highlight DHCP and press the spacebar to toggle to Disabled .
DHCP is currently supported by and does not appear under IPv6.
DS300f G2 Series User Manual
C (Clu)
onneCtIon
S (clu)
ettInGS