led
d
a
s
Isplay
Mber or
LEDs are used on ASUS DS300f G2's:
• Front Panel LEDs (page 202)
• Drive Carrier LEDs (page 203)
• Back Panel LEDs (page 203)
f
P
leD
ront
anel
S
When the power is switched on, the LEDs on the front of the ASUS DS300f G2 light up.
When boot-up is finished and the ASUS DS300f G2 is functioning normally:
• Power, Global Enclosure Status, and Global RAID Status LEDs display green continuously.
• Controller Activity LED flashes green when there is controller activity.
• System Heartbeat LED blinks blue (once a second), and repeats the pattern.
Steady means the LED is on.
Blinking means a regular on/off pattern.
Flashing means an intermittent and irregular on/off pattern.
Dark means the LED is off.
LED State Power
Global Enclosure Status Global RAID Status
Dark
No power
Steady
All devices normal
Green
Steady Blue
Normal
Blinking
—
Blue
Flashing
—
Locating device
Green
Amber
—
One or two devices in error
Red
—
Three or more devices in error
202
r
ed
—
All LDs are on line
—
—
—
One or more LD is critical; none
are offline
One or more LD is offline
Figure 8 - 1: Front panel LEDs right side
See "Enclosure Problems" on page 209, "RAID Controller Problems" on page 211, and "Disk Array and Logical
Drive Problems" on page 213 for more information.
The Locator feature is triggered from ASUS Storage Management or the CLU. It causes the LEDs to blink on and
off for one minute. That action helps you find the physical component.
Controller Activity System Heartbeat
No Controller in Slot
—
—
No activity
Activity
Normal**
—
—
—
—
—
DS300f G2 Series User Manual
Power
Global Enclosure Status
Global RAID Status
Controller 1 Activity
Controller 2 Activity
System Heartbeat