Asus DS300j G2 Series User Manual page 44

v m P S
Irtual anaGement ort ettInGS
M v M P s – A
Aking irtuAl AnAgeMent ort ettings
Automatic settings require a DHCP server on your network. DHCP is currently supported on IPv4 only.
To enable automatic management port settings:
net -a mod -f ipv4 -s "dhcp=enable"
1. At the command prompt, type
administrator@cli> net -a mod -f ipv4 -s "dhcp=enable"
After a moment, the comand prompt reappears, indicating that your setting was successful.
administrator@cli>
2. To verify the setting change, at the command prompt, type
displays:
administrator@cli> net
==========================================
PF Status IP
==========================================
IPv4 Enabled 10.0.0.1
IPv6 Disabled :: Up
In the above example:
• PF refers to IP protocol family, v4 or v6
• Status refers to whether the IP protocol is enabled. IPv4 is enabled by default.
• IP is the virtual management port IP address.
• Link indicates whether there is a working network connection.
By default, IPv4 is enabled and IPv6 is disabled. Currently IPv6 does not suppport DHCP.
M v M P s – M
Aking irtuAl AnAgeMent ort ettings
To make IPv4 settings manually on the management port:
net -a mod -f ipv4 -s
1. At the command prompt, type
• primaryip= and the IP address ,
• primaryipmask= and the subnet mask ,
• primarydns= and the DNS server IP address ,
• gateway= and the Gateway server IP address
" and press Enter .
38
utoMAticAlly
and press Enter .
net
and press Enter . The following information
Link
Up
iP 4
AnuAlly under v
" followed by:
Example:
administrator@cli> net -a mod -f ipv4 -s "primaryip=10.0.0.1, primaryipmask=
255.255.255.0,primarydns=10.0.0.11,gateway=10.0.0.1"
After a moment, the comand prompt reappears, indicating that your setting was successful.
administrator@cli>
2. To verify the settings, at the command prompt, type net -a list -v and press Enter .
The following information displays:
administrator@cli> net -a list -v
----------------------------------------------------------------------------
ActiveCtrlId: 1 Port: 1
MaxSupportedSpeed: 1000Mbps LinkStatus: Up
ProtocolFamily: IPv4(Enabled)
IP: 10.0.0.1
IPMask: 255.255.255.0
MAC: 00:01:55:61:18:65
DNS: 10.0.0.11
Gateway: 10.0.0.1
ProtocolFamily: IPv6(Disabled)
IP: ::
IPMask: ::
MAC: 00:01:55:61:18:65
DNS: ::
Gateway: ::
M v M P s – M
Aking irtuAl AnAgeMent ort ettings
To make IPv6 settings manually on the management port:
1. At the command prompt, type net -a enable -f ipv6
After a moment, the comand prompt reappears, indicating that your setting was successful.
administrator@cli>
2. At the command prompt, type net -a mod -f ipv6 -s " followed by:
• primaryip= and the IP address ,
• primaryipmask= and the subnet mask ,
• primarydns= and the DNS server IP address ,
• gateway= and the Gateway server IP address
" and press Enter .
DS300f G2 Series User Manual
DHCP: Disabled
DHCP: Disabled
iP 6
AnuAlly under v
and press Enter to enable IPv6 on the ASUS DS300f G2.