Ip A Ddresses; Ip A Ddress; Cli - Asus DS300j G2 Series User Manual

Disk array subsystems
Table of Contents

Advertisement

a
Ip a
bout
ddresses
• ASUS DS300f G2 Default IP Addresses (page 36)
• Choosing DHCP or a Static IP Address (page 36)
• Accessing the MAC Address in the CLI (page 36)
• Accessing the MAC Address in the CLU (page 37)
Choosing the appropriate IP addresses is essential to manage your ASUS DS300f G2 subsystem over a network.
You must change the IP addresses of the subsystems as required for your environment.
aSuS DS300
G2 D
IP a
f
efault
DDreSSeS
The default virtual management port IP addresses are set to:
• IPv4 – 10.0.0.1
• IPv6 – 2001::1
The virtual management port IP address works with either RAID controller, enabling you to access a dual-
controller ASUS DS300f G2 over your network using a single IP address.
The default physical management port IP addresses are set to:
• Controller 1, IPv4 – 10.0.0.2
• Controller 1, IPv6 – 2001::2
• Controller 2, IPv4 – 10.0.0.3
• Controller 2, IPv6 – 2001::3
The physical management port IP address works with only one RAID controller and is used when the controller
goes into maintenance mode. For more information, see "Maintenance Mode" on page <?>.
36
c
DhcP
S
IP a
hooSInG
or a
tatIc
DDreSS
When you setup your ASUS DS300f G2, you have the option of:
• Enabling DHCP and letting your DHCP server assign the IP address to the ASUS DS300f G2's virtual
management port.
• Specifying a static IP address for the ASUS DS300f G2's virtual management port.
DHCP is currently supported on IPv4 only. If you use IPv6, you must make your network settings manually.
If you choose to enable DHCP, have your Network Administrator dedicate an IP address for the ASUS DS300f
G2, linked to the ASUS DS300f G2's MAC address. This action prevents the DHCP server from assigning a new IP
address when the ASUS DS300f G2 restarts, with the result that users can no longer log in.
a
mac a
cceSSInG the
DDreSS In the
To access the MAC address in the CLI:
At the command prompt, type net -a list -v and press Enter .
The following information displays:
administrator@cli> net -a list -v
----------------------------------------------------------------------------
ActiveCtrlId: 1
Port: 1
MaxSupportedSpeed: 1000Mbps LinkStatus: Up
ProtocolFamily: IPv4(Enabled)
IP: 10.0.0.1
IPMask: 0.0.0.0
MAC: 00:01:55:61:18:65
DNS: 0.0.0.0
Gateway: 0.0.0.0
ProtocolFamily: IPv6(Disabled)
IP: ::
IPMask: ::
MAC: 00:01:55:61:18:65
DNS: ::
Gateway: ::
DS300f G2 Series User Manual

clI

DHCP: Disabled
DHCP: Disabled

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ds300f g2 seriesDs300 g2 series

Table of Contents