Asus DS300j G2 Series User Manual page 85

SlP S
ervIce
Service Location Protocol (SLP) discovers services over the Internet. SLP applies to IPv4 protocol only.
s slP s
toPPing ervice
To stop the SLP service:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SLP service and click the Stop button.
4. Click the Confirm button.
To start the SLP service after stopping it:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SLP service and click the Start button.
r slP s
estArting ervice
To restart the SLP service:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SLP service and click the Restart button.
M slP s
Aking ettings
To change SLP service settings:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SLP service and click the Settings button.
4. Choose a startup type:
• Automatic – (default) Starts and runs with the subsystem.
• Manual – You start the service when you need it.
5. Click the Save button.
6. Click the Confirm button.
79
w S
ebServer ervIce
Webserver service connects the ASUS Storage Management interface to the RAID subsystem though your
browser.
s w s
toPPing ebserver ervice
To stop the Webserver service:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the Webserver service and click the Stop button.
4. Click the Confirm button.
To start the Webserver service after stopping it:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the Webserver service and click the Start button.
r w s
estArting ebserver ervice
1. Click the Administration tab.
2. Click the Services icon.
3. Click the Webserver service and click the Restart button.
M w s
Aking ebserver ettings
To change Webserver service settings:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the Webserver service and click the Settings button.
4. Make settings changes as required:
• Choose a startup type,
Automatic – (default) Starts and runs with the subsystem.
Manual – You start the service when you need it.
• Session Time Out – Default is 24 minutes.
5. Click the Save button.
6. Click the Confirm button.
DS300f G2 Series User Manual